#BEHRINGER S 16 ON DIGI002 UPDATE#
Note: If a warning pops up telling you that the mixer firmware is not supported, it is recommended to update the firmware to the latest version. Tap on the mixer’s icon to connect the app with your mixer.Except Ive come to hate the way that pre sounds. This setup has worked for me for a few years now. Open the X Air for iPad app and it will show any X Air mixers found in that network with their IP address. To shove more mic inputs into it, I bought a Presonus DigiMax LT preamp that feeds 8 mic signals via lightpipe to the Digi.I just hit record at the start of the gig and it captures everything I need for remixing later. At the X32, set the Synchronization to AES50A, then turn on the S16. Second, disconnect the second S16 for a moment. After a few seconds, the status should change to Connected. So now I can record 16 individual tracks onto the LR16 independently and at the same time whilst still using all the S16's functions and best of all it all fits nicely into a 6U SHORT rack for placing on stage. First, go to your profile and change your name to your real first and last names, as required by forum rules. From the lists of networks, select your X Air mixer’s name (e.g.Open Settings, then tap on Wi-Fi and turn Wi-Fi on.Once the app is connected to your mixer, all parameters will be loaded automatically.You can, however, choose to connect anyway. Click on Connect and tap on the mixer’s name in order to connect the app with your mixer.You may choose to lock the connection to this specific Wifi network if you want to ensure that your device cannot automatically connect to another network while you are controlling your mixer.Open your X AIR for Android app and it will show information similar to the following:.After a few seconds, the status should change to Connected.
From the lists of networks, select your X Air mixer’s name (e.g. Start the Settings/Wireless & Networks dialog on your Android device and switch Wifi on.On your mobile device, open the network settings, then follow the directions below according to your device.Reset your X AIR mixer’s network settings by holding the reset button (located in the small hole above the WIFI icon) for 2 seconds using a paperclip or similar tool.Set the Remote switch on your your X Air mixer to Access Point mode and power on the mixer.
#BEHRINGER S 16 ON DIGI002 INSTALL#